# Ender 5 Plus Hotend runaway

**URL:** <https://3dprintingspace.com/t/ender-5-plus-hotend-runaway/7442>\
**Category:** Creality Ender 5 Plus\
**Created:** [December 14, 2023, 2:03am UTC](https://3dprintingspace.com/t/ender-5-plus-hotend-runaway/7442 "2023-12-14T02:03:51Z")\
**Posts on this page:** 2\
**Page:** 1

<div class="post-metadata">

**Author:** ![Steven](https://3dps-assets.b-cdn.net/letter_avatar_proxy/v4/letter/s/94ad74/32.png) [@Steven](https://3dprintingspace.com/u/Steven)\
**Post date:** [December 14, 2023, 2:03am UTC](https://3dprintingspace.com/t/ender-5-plus-hotend-runaway/7442/1 "2023-12-14T02:03:51Z")

</div>

Good day  
Hope someone may have some insight into my problem. I have an Ender 5 Plus has been running well since I got it then this. I am having a Hotend Runaway when I turn the machine on the Head starts to heat up and will not stop till I turn the Machine off. I have replaced the Hotend complete and did a PID and it failed due to high a temp . Then I just replaced the Mosfet and it does the same when I turn power on temp goes very high. PID failed due to high a temp again. Is this going to be a board replacement or is there something I am missing. The screen shows all the output when I turn it on but the Temp goes up.

Thanks

Look forward to your feed back

Steven

---

<div class="post-metadata">

**Author:** ![SeanSemple](https://3dps-assets.b-cdn.net/letter_avatar_proxy/v4/letter/s/d26b3c/32.png) [@SeanSemple](https://3dprintingspace.com/u/SeanSemple)\
**Post date:** [January 14, 2024, 3:48am UTC](https://3dprintingspace.com/t/ender-5-plus-hotend-runaway/7442/2 "2024-01-14T03:48:44Z")

</div>

When you did the complete hot end replacement, is it possible you grabbed the wrong voltage cartridge for the machine? I did this with an gen 1 E3 and had the same issue as reported.