I’m wondering if anyone here has done an upgrade on a cheaper printer to 300+ nozzle temperature and upgraded the bed as well. I’m trying to avoid spending 4K+ on a printer that prints exotic materials when I can spend less and just tinker a little bit with the settings and parts.
I have been thinking about that too. The big question I have is can the electronics (motherboard and power supply) handle the increased power draw.
I have done the upgrades of our modix to 360 deg, It’s not a fancy hot end although very effective.
It’s a Titian Aero volcano. Very effective and yes can be easily upgraded to run 300 Plus temps.