This Tree of our Forum is dedicated to questions comments, Problems and concerns about the Creality CR-10 Smart/Smart Pro 3D printer.
Feel free to post here, It will show up in the general thread tracker so anyone may respond.
Hi I have a Creality CR-10 Smart Pro with a Sonic Pad.
Recently, the printer stops mid print and the Sonic Pad reports printing is paused.
I am unable to unpause the print. I am stuck in a endless loop of pressing unpause. I could not software quit the print either.
After a forced shutdown (power off) I checked for blockage etc and could find no blockage or physical / electrical faults. I am not sure if it is the printer or the pad.
Anyone have any ideas on what the problem might be?
Opps, I am not familiar with forums. I seem to have put this in the wrong place. Not sure how to correct my error