So I’ve discovered it’s possible to change e-steps in the middle of printing, at least on my printer. So I’m making a box and it’s going to have a color change after a certain layer but I changed my mind on the colours when I got the filament out. The filament I changed to I have to adjust the e-steps for and forgot until I saw it under extruding on the first layer. So I paused it and used the new built-in utility to adjust the e-steps and when it was done all I had to do was hit resume and off it went. I’ll have to do it again at the filament change point so I’m glad it works. the messed up section is going to be hidden