Hi LEGO, Jason and Kieth,
I changed the extrude heavy original stepper motor by a pancake Bontech. My Ender 5 PLus has been upgraded with a Micro Swiss direct extruder earlier. I did not know that cables were a matter that they might not be the same configuration. Then the machine had strange noise at the new motor and getting hot. I was scared then changed it back. Now It go wrong with the motor gear back and forth.
Keith has helped me to config the cable by changing the order of 1346 to new order 1436, at the mean time to reinstall the firmware from Ender-5PlusBLTouch__V1.70.2 BL.hex and Pronterface M92 E0 140.00, M500
Please see the Pronterface report attached herewith:
I did exactly as guided but it is not fixed. Please give me an advise If I might have missed something. Right now the machine can heat up fine, calibration fine, everything is fine but extrude and retract modes are not functioning nor printing. Thank you very much.
Preformatted text