Hey Mykepredko,
So I was not this notification, I was like “no way it’s it wiring issue, I’ve been running this wiring for over a year…”
I flip the printer over to get the photo and notices that the Positive wire for the Heated Bed had come loose. Unmounted the Board, checked the connector, secured it back into place, pre-heated to 40°, and then to 60°, finally to 70° with no issues.
I’ll have to do a quick bed level, and I’ll have to do a test print.
The cable going to the Mosfet looked a little flat, what is the best way to attach them without crushing them?
I do appreciate it, working in I.T it’s usually the easiest answer 