Filament extruding wrong, need help

I have done pretty good 3d printing objects until my nozzle broke, and my new one has been working great, but all of a sudden this happened:
Here are my settings:

If anyone knows what is happening it would help a great deal. Thanks for everything!

Looks like your nozzle is too low - did you recalibrate your hot end before trying it again?

What do you mean by recalibrating the hot end?

Check the height of the nozzle using “The paper test” and modifying the settings in your printer.

Based on your photographs, what is put down looks a bit “squished” (for lack of a better term), like the new nozzle is slightly lower than the old one.


Wow, that helped a lot. Thanks!