Fresh off the printer after a hotend replacement!

6 Likes

Wow, that is amazing!

Awesome ONI mask Chris!

Looks very good! Can’t be upset with those results.

You didn’t, per chance, try printing this with the old hotend?

I see lots of people wanting to upgrade the hotend, but I’ve yet to see side-by-side comparisons done on the same printer to determine if some of the newer hotends really make that much of a difference.

I have a print someplace from a Dragon I’ll have to find it. It was ok but I had a power failure and sometime after the recovery the print broke loose of the bed. It was a nightmare to clean the plastic out of the screw holes. it is in a box someplace. It was about the same as the E3D, I didn’t get the hype.