2 Likes
Cmon. The 6 has an interface problem. You can level your bed until Morty has an out of body experience. The z offset doesn’t work.
Wasn’t this issue resolved in the latest firmware release?
No. It doesn’t save to Eprom, or it does but drifts, or something else entirely that I could never figure out.
I went with another firmware altogether to fix it.
Got it - Can you post the link to it?
Thanks
Sure I used this walk-through.
It still does not solve your spiralize/vase mode problem.
When they start selling chips for reasonable prices again, I’ll buy a pi and try Klipper.
It’s a solid machine, but I can’t believe how bad they pooched the interface and firmware…