Kywoo IDEX Z axis issues

Good Day,
I posted this in one of the other categories but may not have been the right form.
Is there a mechanical adjustment that can be made for either or both the extruders on the Kywoo IDEX?

I am having issues printing in duplicate or mirror mode.
If I get the primary extruder set properly, the 2nd extruder runs too close to the bed causing it to jam up.
If I get the Z correct for the 2nd extruder the 1st extruder is to high to print onto the bed.

HELP, SUGGESTIONS ?
I’m losing it after spending 3 - 4 days trying to tune it.