Smoother prints with Arc Welder for your slicer

3D Printer Slicers
1

I’ve been trying this out with Cura and my prints are coming out a lot smoother and the gcode files are nowhere near as large.

2

Thank you for the tip! Definitely will take this into consideration!

3

Interesting, depending on your firmware you may need to recompile and enable arc support before using this.

I wonder how it would affect models with low resolution and whether or not it would improve that as well.

4

Oh cool! …going to add that to my Cura

5

that’s cool, I just watched the video on it,

NEXT UPGRADE - FREE $$

6

I’m on a mac, so I am going to have to wait till I set up an octoprint to try this out.

7

I use a Mac as well, it was an easy install in Cura, no problems