Error Key 111: Unkown Exception

[NickGarai]

I replaced the Hot end and Adapter Card on my K1 Max. All of the wires are connected correctly. I am still receiving an Error: Key 111 Unknown Exception message.

I cannot even run the self check feature. Can someone help me to fix this? What am I doing wrong?

[Loosenut]

@NickGarai

Error: Key 111

Check this out:
(111 Error Trouble Shooting | Creality Wiki

[kitedemon]

Abnormal nozzle error key 111 unknown exception

Hi all I bought the new Micro Swiss hot end for my K1 but it only worked great for about 30 seconds before an issue with my nozzle board (connector breaking) triggering “error key 111 unknown exception” (picture 1 &2) [PXL_20231214_155556037] [PXL_20231214_155617300] forced me to set things aside. Got the new board in but I’m still getting the error. When I press “restart” until the error goes away and run through the setup self check it gets stuck at the first item “nozzle heating” then g…

It’s a board connection issue, where the troubleshooting should help .